Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

can't 'see' ws-G5483=

i just purchased 10 of these (from overseas but they are genuine Made in America which match exactly to 3 i've had for years).

none of them will come up (in a 3548) but the 3 i've had come up immediately.

i don't get it

1 ACCEPTED SOLUTION

Accepted Solutions

Re: can't 'see' ws-G5483=

Any messages in the log? If you're not monitoring, those can slip by. I would expect some form of "unrecognized interface type" message if IOS is unhappy.

Also see if inserting them while the switch is powered down (if you can).

Paul

2 REPLIES

Re: can't 'see' ws-G5483=

Any messages in the log? If you're not monitoring, those can slip by. I would expect some form of "unrecognized interface type" message if IOS is unhappy.

Also see if inserting them while the switch is powered down (if you can).

Paul

New Member

Re: can't 'see' ws-G5483=

hey, dude, that was it! powered off plugged it in and i have a link! THANKS

102
Views
0
Helpful
2
Replies
CreatePlease to create content