Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Can't view boot sequence on NM-NAM

Hi,

Trying to reset the root password on an NM-NAM in 15.1. I have the instrcutions, however when I do a reload I can never get and console outout so I can type in "***". The session doesn't repsond until the NM-NAM has reloaded, i.e. I can never see the boot sequence.

Shark#service-module analysis-module 1/0 reload

Do you want to proceed with reload?[confirm]

Trying to reload Service Module Analysis-Module1/0.

Shark#service-module analysis-module 1/0 session

Trying 192.168.2.1, 2066 ... Open

Authorized access only!

User Access Verification

Username:

Any ideas?

Simon

3 REPLIES
New Member

Can't view boot sequence on NM-NAM

Ok - so for some reason when I open a session with the NM-NAM, I actually end up telneting to the router itself, not the NM-NAM - I'm confused now...

Silver

Can't view boot sequence on NM-NAM

You may have a general router login authentication rule for all lines (including reverse telnet to NAM). After entering username and password, are you already connected to NAM console?

Post your aaa and line config and the output you get after authenticating.

New Member

Can't view boot sequence on NM-NAM

Peter - thanks for your response - yes, that was the problem. I didn't follow the instructions to turn off aaa for line 66.

thanks,

Simon

166
Views
0
Helpful
3
Replies
CreatePlease to create content