Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can't view link properties in Network Assistant

Not a big issue at all....I have the latest version of Cisco Network Assistant running.  I have a

series of 2960G switches connected in a community.  I also have a 1240 series Access Point in the community as well.  So far a total of 6 devices.

I have two Cisco bridges that I cannot look at the link properties on for each link between the bridges and the switch they are connected to.  One bridge is an old 350 series bridge, and the other is a 1310 bridge.  I thought I should be able to right-click the link in the Network Assistant diagram and look at the link properties like I can with the other devices, but not with these two bridges.

Thoughts as to why?

166
Views
0
Helpful
0
Replies