Not a big issue at all....I have the latest version of Cisco Network Assistant running. I have a
series of 2960G switches connected in a community. I also have a 1240 series Access Point in the community as well. So far a total of 6 devices.
I have two Cisco bridges that I cannot look at the link properties on for each link between the bridges and the switch they are connected to. One bridge is an old 350 series bridge, and the other is a 1310 bridge. I thought I should be able to right-click the link in the Network Assistant diagram and look at the link properties like I can with the other devices, but not with these two bridges.
Thoughts as to why?
