Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can`t we configure peer-link on M1 cards?

can`t we configure peer-link on M1 cards? its showing an error while i am configuring the vpc peer link on M1 card.

ERROR: Operation failed: [Interface is not capable of acting as peer-link]

Everyone's tags (2)
1 REPLY

Re: can`t we configure peer-link on M1 cards?

Hi,

The PC peer link can be configured on M1 series I/O modules, but only on the 10GE modules. From the Configuring vPC section of the Nexus 7000 configuration guide:

vPC Peer Links

A vPC peer link is the link that is used to synchronize the states between the vPC peer devices. Both ends of the link must be on 10-Gigabit Ethernet interfaces.

What type are your M1 I/O modules? I can't see from what you attached.

Regards

79
Views
0
Helpful
1
Replies