I have tried all speeds from 1200 to 115200 to accees the port. I can see activity on the router on FA 0/0, EiGRP broadcasts, the ip address of the interface, even the version of IOS but I don't have the password or a printed config. I need access to console port and am willing to wipe the entire config etc and start from scratch. Any suggestions? I have also noted a jumper inside labeled reset but not been able to find any Cisco docs on what this jumper is for?
what do u get on console ? no messages at all ?? is this a working router ? you have to go on console and break the password, no other go now !! if console messages arent comin its also worthwhile to check ur hyperterminal.. u can also probably use some other software like securecrt and see if you are able to get any message....
I get no messages at all via hyperterminal. The router boots, lights flash green as it boots. I see it sending out broadcasts, EIGRP info, etc when capturing packets connected via Xover cable/laptop via ethernet 0. I will try securecrt.
It looks like the connector was dirty? I verified my laptop/cable then came back to this router and now it is working... and I had tried it multiple times switching the cable back and forth between the two ports.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.