Cannot access Internet after configure inter-vlan routing using a Catalyst 3550 switch
My network used to be one vlan (vlan1). All devices on the network to point to my PIX as the default gateway to the Internet. Since, I vlan-ed the network into multiple vlans using the ip routing feature on the 3550, I cannot access the Internet.
I basically follow the sample configuration found on the Cisco Document ID 41260 (Configuring InterVLAN Routing with Catalyst 3750/3560/3550 Series Switches) to setup the attached Cat 3550 configuration.The Pix configuration is my current one flat layer network configuration.
Please advice as to what I missed or did wrong that I cannot access the Internet with this setup. Thanks
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.