Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k

cannot change the baudrate back to 9600

i have a 3560v2 switch and i cannot set the baudrate back to 9600 , (i tried lin con 0 , speed command) but after reload the switch it goesback to 38400

and tried (unset baud) & set badu from rommon but no thing

how i save the baudrate to 9600 even when i restart the switch

regards

2 REPLIES

cannot change the baudrate back to 9600

A couple of things you could check. Make sure that your config register is set correctly to 0x2102 by looking at "sh ver". If that's set correctly, try going under the line and do "default speed" and save the changes. Then reboot to see if the changes are set.

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***

cannot change the baudrate back to 9600

there is no config refister as it is a switch layer 2 not router

171
Views
0
Helpful
2
Replies
CreatePlease to create content