Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot configure QoS service policy on VLAN interface

When trying to configure a service policy on a VLAN interface it comes back with

Switch(config-if)#service-policy input TEST

Master SVI send all failed for interface Vlan310, cmd = 38

Service Policy attachment failed

Switch(config-if)#

Switch is a 3750 stack IOS 12.2(25)SEB4

I can apply policy to other layer 3 interfaces with no problems.

3 REPLIES
Silver

Re: Cannot configure QoS service policy on VLAN interface

Make sure SDM PREFER ROUTING is enabled and then reload the switch.See if it works out.Refer the following URL

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a00801e7bb9.shtml

New Member

Re: Cannot configure QoS service policy on VLAN interface

Paul,

service-policy is allowed only on physical interfaces but not in virtual interfaces.

HTH

Regards,

Suresh

Silver

Re: Cannot configure QoS service policy on VLAN interface

Hi Paul,

The following are the links helps while configuring the policies for 3750.

Policing and policy-maps are only supported on ingress for the 3750. After you configure

the policy map and policing actions, attach the policy to an ingress port by using the

service-policy interface configuration command

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750scg/

swqos.htm#wp1024977

You can attach only one policy map per ingress port

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750scg/

swqos.htm#wp1044737

1481
Views
0
Helpful
3
Replies
CreatePlease login to create content