After using my WVC200 wirelessly (and thru DDNS service) for about a year without any problems I just moved and got a new router (Actiontec MI424WR Rev. F) from my previous service provider (Verizon FiOS).
Unfortunately, after hours of trying to view the camera wirelessly, for some unknown reason my router can not find the camera wirelessly. It only works when the Ethernet cable is connected to it.
I check all the settings at least 5 times (SSID, WAP, Addresses, etc) but that did not fix the problem. Then, I re-set the camera and try to do a “fresh” re-install but now the software (that came with the camera) can not find the camera wired or wirelessly no matter how many times I try yet I can still access the camera via the Ethernet cable (by typing the address into IE) but no wirelessly.
Does anyone know how to fix this and make the camera wireless again? Please advice.Thank you.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.