Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

cannot delete a nat overload...

I can't remove a line from my config:

Router(config)#no ip nat inside source list 101 pool MY_POOL overload

Dynamic mapping in use, do you want to delete all entries? [no]: y

%Error: Dynamic mapping still in use, cannot remove

Router(config)#int g0/1.1

Router(config-subif)#no ip nat inside

Router(config-subif)#end

Router#clear ip nat translation *

Router#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#no ip nat inside source list 101 pool MY_POOL overload

Dynamic mapping in use, do you want to delete all entries? [no]: y

%Error: Dynamic mapping still in use, cannot remove

Router(config)#int g0/1.1

Router(config-subif)#ip nat inside

Router(config-subif)#end

I don't even have a access-list of 101 and I don't have a pool setup called MY_POOL:

Router#sh ip access-list 101

Router#sh run | i MY_POOL

ip nat inside source list 101 pool MY_POOL overload

Router#

How can I remove this thing? I'm stumped.

2 REPLIES
Hall of Fame Super Gold

Re: cannot delete a nat overload...

Classic IOS bug. Configure no nat on interface as you're doing, reload, change nat as needed.

Hall of Fame Super Bronze

Re: cannot delete a nat overload...

It's a timing issue. Please refer to this URL for more information

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094422.shtml

In short, keep trying :)

You can also shut the interface down, if possible.

HTH,

__

Edison.

4073
Views
5
Helpful
2
Replies
CreatePlease to create content