Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cannot issue ip policy route-map to an interface

Hi There

I am currenlty trying to apply a basic route map to an interface on a 3750. I set the sdm prefer routing command and rebooted the switch.I now have number of IPv4 policy based routing aces: 512 in the #sh sdm but I still dont have access to the command #ip policy would anyone have any suggestions

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: cannot issue ip policy route-map to an interface

your interface must be a L3 one(using no switchport command).

is it a L3 interface?

2 REPLIES
Silver

Re: cannot issue ip policy route-map to an interface

your interface must be a L3 one(using no switchport command).

is it a L3 interface?

New Member

Re: cannot issue ip policy route-map to an interface

Of course thank you. Its actually an L2 port channel in trunk mode. Back to the drawing board I think

120
Views
0
Helpful
2
Replies
CreatePlease to create content