Hello, I have configured two switches with loopback interfaces (both on same subnet). The two switches are connected with a trunk. Why can I not ping between these two switches (loopback addresses). Are loopback interfaces on switches not supposed to be used this way ?
What is your switches and how did you configured, can you share configuration. You can configure as below with vlan interfaces. You can not ping loopback interfaces you need to add route for loopback interfaces.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...