Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cannot Ping

I have a setup of two L3 switches and one router. Am I missing something very fundamental here, or this is a GNS3 error?

Thanks in advance for any help!

gns3-SS.png

I can ping from 10.99.99.3 to 10.99.99.1 and visa versa. However, I cannot ping from 10.99.99.3 to 10.99.99.2, or visa versa.

Here is the pertinent config:

10.99.99.1

!

interface Vlan99

ip address 10.99.99.1 255.255.255.0

!

interface FastEthernet1/3

switchport access vlan 99

duplex full

speed 100

!

10.99.99.2

!

interface Vlan99

ip address 10.99.99.2 255.255.255.0

!

interface FastEthernet1/3

switchport access vlan 99

!        

interface FastEthernet1/4

switchport access vlan 99

10.99.99.3

!

interface FastEthernet0/0

ip address 10.99.99.3 255.255.255.0

speed 100

full-duplex

!

Ping and ARP


LEFT-L3#ping 10.99.99.3

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.99.99.3, timeout is 2 seconds:

.....

Success rate is 0 percent (0/5)

PK10-L3#sho ip arp 10.99.99.3

Protocol  Address          Age (min)  Hardware Addr   Type   Interface

Internet  10.99.99.3              0   Incomplete      ARPA  

**********************

RIGHT-L3#ping 10.99.99.3

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.99.99.3, timeout is 2 seconds:

.....

Success rate is 0 percent (0/5)

RIGHT-L3#show ip arp 10.99.99.3

Protocol  Address          Age (min)  Hardware Addr   Type   Interface

Internet  10.99.99.3              0   Incomplete      ARPA  

****************************************

CRMS#sho ip arp

Protocol  Address          Age (min)  Hardware Addr   Type   Interface

Internet  10.99.99.2              0   Incomplete      ARPA  

Internet  10.99.99.3              -   c209.0ee4.0000  ARPA   FastEthernet0/0

Internet  10.99.99.1              0   Incomplete      ARPA  

Everyone's tags (5)
1 REPLY
VIP Super Bronze

Cannot Ping

Can you try removing

speed 100

full-duplex

and test again?

HTH

181
Views
0
Helpful
1
Replies
CreatePlease to create content