I have a Cisco 2950 switch connected to a Cisco 4507 with
GBICs and fiber. Just recently the C2950 started to be unresponsive to pings and when successful the response time is around 1800ms. The switch is servicing clients fine and I can ping clients off this switch fine with 1ms respose times. CPU and memory look to be fine as well.
Here is what i have done so far...
Copied the config to a new Switch (slightly different IOS), moved all connections and the issue remianed.
Removed the GBIC trunk connection to the 4507 and patched (with Copper) the switch into another switch connected to the 4507. Issue was gone for about 15min then resurfaced.
Connected the original switch with GBICs and fiber back into the 4507 with a different name and IP address. This switch responds to pings and management fine.
Moved a few connections back to the original switch and still fine.
I am now left with moving a few connections at a time from the problem switch to the original switch to see if one clears up and the other begins to have problems.
Anyone have an ideas of a possible cause here or may have seen something similar before?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...