Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cannot Telnet - 6506

Hi,

6506 is in hybrid mode, cannot telnet to it anymore. Could be telnet sessions are full and didnt clear.

how can I clear the telnet session.

I am able to login to switch module on the 6506

Without restarting the box or disturbing any services can we clear the session

5 REPLIES

Re: Cannot Telnet - 6506

Hello.

Login to the switch module and then to get to the console of the MSFCs do 'session 15' and/or 'session 16'

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bfa9.shtml

Simon

New Member

Re: Cannot Telnet - 6506

Why telnet session doesnt timeout in 15 min.

any other commands rquired to timeout telnet session in 15min

New Member

Re: Cannot Telnet - 6506

There is a bug with one of the os on the cat6000 that does not release the telnet sessions after they should be timing out. Once you are in, there is a command to issue that shows the users currently telnetted and you should be able to clear them. I forgot the commands though, sorry. This was on a CATOS 6500 switch though, not sure if the bug exists on CIOS switches. If your run CATOS, then that might be something you should look into to.

GL

New Member

Re: Cannot Telnet - 6506

Have you tried 'clear line'?

New Member

Re: Cannot Telnet - 6506

Login to the switch module and then to get to the console of the MSFCs do 'session 15' and/or 'session 16'

This step switches to MSFC console from SUP console only rather than clearing telnet sessions. Plz correct me if i'm wrong.

349
Views
0
Helpful
5
Replies