08-06-2013 07:25 PM - edited 03-07-2019 02:47 PM
hi everyone!
just bought sg200-26p switch and trying to configure it in the CLI environment but i cant telnet the switch, when i went through the switch using the browser i notice that there is no telnet available in the TCP/UDP settings. any idea how i can manage the switch using CLI. thanks
Sincerely,
Rolf
Solved! Go to Solution.
08-06-2013 08:42 PM
SG200 switches are only GUI configurable. The SG200E model only does support CLI.
Regards,
08-07-2013 01:10 AM
Check Cisco 200 Series Switches Data Sheet
According to this document it support both trunking and up to 4 etherchannels simultaneously.
If my ansswers were helpfull, dont forget to rate them.
Regards,
08-06-2013 07:28 PM
also i just upgraded it to the latest firmware, but still telnet not working.
08-06-2013 08:42 PM
SG200 switches are only GUI configurable. The SG200E model only does support CLI.
Regards,
08-06-2013 11:51 PM
Thanks, can i enable trunking or etherchannel on this switch? pls. let me know how.
Rolf
08-07-2013 01:10 AM
Check Cisco 200 Series Switches Data Sheet
According to this document it support both trunking and up to 4 etherchannels simultaneously.
If my ansswers were helpfull, dont forget to rate them.
Regards,
08-08-2013 02:35 PM
Wrong forum, post in "small business switches". You can move your post using the actions panel on the right.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide