Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot telnet to certain remote switches

We have around 50 remotes switches which are connected via a lease line, only 3 switches are not able to telnet, while try to telnet:

The switch will stop responding to the monitoring system, ping will request timeout (before telnet to the switch, that switch can be ping all the time)

After reboot the switch can telnet without any problem and can be ping (after 15 minutes then will back to above scenario, try telnet will fail and cannot ping anymore)

While console to the switch, no error message show on the log, or high cpu or any unusual issue.

Above problem switches are running is different IOS version, like:

c2950-i6q4l2-mz.121-12c.EA1.bin

c2950-i6q4l2-mz.121-9.EA1.bin

c2950-i6q4l2-mz.121-6.EA2a.bin

Some remote switches running above IOS and same configuration, but without any issue to telnet it, only these 3 switches having the problems.

Similar to below case:

https://supportforums.cisco.com/thread/27315

1 REPLY

Cannot telnet to certain remote switches

You should do a trace and see where it fails then check the routing also arp entry for IP address. Last hop might show you some logs.

355
Views
0
Helpful
1
Replies
CreatePlease login to create content