Here's my dilemma. We currently have 2 span sessions created on our core switch 6509, one for an IDS and the other for a websense server. I currently only have 1 vlan configured but that will change. We have 20+ edge switches and branch locations. We just invested in a Sniffer. If we still want to keep these other two span sessions, what other options do I have?
Options presented: 1. Purchase a tap. Seems expensive
2. I read that I could set up a span session on a switch and have the traffic routed. Is this possible?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...