Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

CAT 3524 Vs CAT2960 support switchport trunk encapsulation dot1q

Dear All,

I would like to know whether this command is supported by CAT2960 switches "switchport trunk encapsulation dot1q". I tried it is not working. Do we have any alternate for this?

Regards

BR

7 REPLIES

Re: CAT 3524 Vs CAT2960 support switchport trunk encapsulation d

Hi ,

The command is not valid.The switch will use by default dot1q.

After configuring the trunk interface you can verify using :

show interface x/y switchport | i Trunking Encapsulation

HTH

Dan

New Member

Re: CAT 3524 Vs CAT2960 support switchport trunk encapsulation d

Dan,

Thank you very much for your information.Can you share some link which say that cat2960 switch will use by default dot1q on trunked interface?

Thanks in advance

Regards

BR

Re: CAT 3524 Vs CAT2960 support switchport trunk encapsulation d

Re: CAT 3524 Vs CAT2960 support switchport trunk encapsulation d

Also :

On Supported VLANs

The switch supports only IEEE 802.1Q trunking methods for sending VLAN traffic over Ethernet ports.

HTH

Dan

New Member

Re: CAT 3524 Vs CAT2960 support switchport trunk encapsulation d

Dear Dan,

I read the shared link but I couldn't see statement that cat2960 swtich support dot1q encapsulation. Please update

Regards

BR

Re: CAT 3524 Vs CAT2960 support switchport trunk encapsulation d

802.1q is dot1q.

Read my previous post.

Dan

New Member

Re: CAT 3524 Vs CAT2960 support switchport trunk encapsulation d

Dear Dan,

Thanks for your inputs. I will check and update you.

Regards

BR

2214
Views
0
Helpful
7
Replies
CreatePlease to create content