Cat 3650 Flexible Netflow

[janvandek]

                   Hi,

What does Activate Netflow in Access (code FNF-LC) do?

I would like to have Netflow on the Cat3650. Therefore I foresee IP BASE (as needed to support Flexible Netflow).

But now, I'm a bit confused because there exist also a SKU  (90Day trail) to activate Netflow in Access (some product from Lancope Stealthwatch).

What does it, and do I need this ? Can I use Netflow whithout this 90D trail?

Thanks for any comment related to this.

Jan

[Don Jacob]

As far as I know Cisco Catalyst 3650 supports Flexible NetFlow with atleast an IP Base - no additional requirements. Simply enable NetFlow on your device, use a flow analyzer (SolarWinds NetFlow Traffic Analyzer, ManageEngine, Plixer Scrutinizer, etc.) and you are ready for NetFlow analysis. Hopefully this should help with your Flexible NetFlow configuration:

And this is a sample for Flexible NetFlow config:

http://thwack.solarwinds.com/community/solarwinds-community/geek-speak_tht/blog/2014/01/22/netflow-and-catalyst-switch-netflow-v9-configuration-for-cisco-catalyst-3850-switch

Regards,
Don Thomas Jacob
http://www.solarwinds.com/netflow-traffic-analyzer.aspx

NOTE: Please rate and close questions if you found any of the answers helpful.