07-15-2009 07:30 AM - edited 03-06-2019 06:46 AM
Hi,
I have a Cat4006 with SUP II and a layer 3 card WS-42342 (router switch card) and this card shows cpu at 97% but when i look to precesses i don't see processes that are consuming cpu.(see a atchment with show cpu proc)
Cat 4000- SUPII - CatOS 7.4.2
Ws-4232 Sw ver. IOS 12.0(25)W5(27)
Also I have HSRP configured between this cat 4006 (standby) and one cat 4507R(Active)
Any suggestions,please?
Thanks
Regards.
MC
07-15-2009 08:07 AM
Most likely interrupt traffic. Need extensive troubleshooting to identify this traffic. This URL may help
http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00804cef15.shtml
HTH,
__
Edison.
07-15-2009 09:27 AM
07-15-2009 09:58 AM
The link I posted also contains a sublink to CatOS, please read the link on detail.
This kind of troubleshooting may require TAC assistance and often is quite extensive.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: