I have a Cat4006 with SUP II and a layer 3 card WS-42342 (router switch card) and this card shows cpu at 97% but when i look to precesses i don't see processes that are consuming cpu.(see a atchment with show cpu proc)
Cat 4000- SUPII - CatOS 7.4.2
Ws-4232 Sw ver. IOS 12.0(25)W5(27)
Also I have HSRP configured between this cat 4006 (standby) and one cat 4507R(Active)
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...