Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat 4500 high CPU

Hello,

for a 4-5 Sec I have high CPU (see below) utilisation on Cat 4510R-E with SUP-6E 12.2.52(SG).

Does someone know what is used for the process GaliosObflFilesy that seams to use so much CPU ?

During this period of time the processor slow down for task as HSRP Hello or/and EIGRP hello etc ...

CPU utilization for five seconds: 72%/0%; one minute: 18%; five minutes: 16%
PID Runtime(ms)   Invoked      uSecs   5Sec   1Min   5Min TTY Process
  74   187729636   5824536      32230 65.75%  7.14%  3.89%   0 GaliosObflFilesy
  53   4199671841761942844        238  3.67%  5.29%  5.38%   0 Cat4k Mgmt HiPri
  54   788931832 520048050       1517  2.23%  5.56%  5.76%   0 Cat4k Mgmt LoPri
148      170944    394107        433  0.23%  0.02%  0.00%   0 IP RIB Update
238     1090396  50798531         21  0.15%  0.03%  0.00%   0 EIGRP-IPv4:
237      988936  50290994         19  0.07%  0.01%  0.00%   0 EIGRP-IPv4:

thank's in adcance ...

Everyone's tags (2)
1 REPLY

Re: Cat 4500 high CPU

Good question...I love looking stuff up like this, but the only reference I could find was here:

http://www.cisco.com/en/US/docs/ios/interface/command/reference/ir_s5.html

Search the doc for Galios

Dont get excited, its not alot of info at all...but might help you.

Good luck,

Jimmy

1594
Views
0
Helpful
1
Replies