Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CAT 6506

we are planning to put redundant SUP 2 for our CAT 6506

Currently the CAT 6506 is booting from boot system flash disk0:s222-advipservicesk9_wan-mz.122-18.SXF10a.bin so the secondary SUP 2 which I am inserting whether it should also be boot from disk 0

Can I know what is difference between Slot0 and Disk 0

Is it depence on the compact flash ?

Thanks

  • LAN Switching and Routing
3 REPLIES

Re: CAT 6506

It depends on the hardware.

Some hardwares call their flash card compartiment: slots and other hardware call them disk.

So depending on what platform you are on it will use either:

slot0, slot1 OR disk0, disk1.

you can not use disk0 on a platform that uses slot0.

In your case on sup2 it's disk0:, disk1:

New Member

Re: CAT 6506

Thanks for your reply

so it depends on the PCMCIA Flash card

Currently we using the SUP 2 in SLOT 1 of the 6506 chassis

now we are going to put the same IOS and same model SUP2 on the SLOT 2 of the 6506 chassis

In live can we put the secondary SUP ?

i am configured SLOT 1 SUP redunanacy mode as SSO

what is difference between RPR+ and SSO ?

in this condition SLOT 1 will be master and synch all config to SLOT 2

Am i right

Silver

Re: CAT 6506

For the older ATA flash cards, I believe 20MB and below, the file system name was Slot0:, now with the higher capacity compact flash cards the switch calls the file system disk0: or disk1: depending which slot you use in the sup.

163
Views
0
Helpful
3
Replies
This widget could not be displayed.