Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat 6513 Module not showing in show config

I have installed new nodule WS-X6148-RJ45V in slot 13 of cat 6513.. It is show in show module.. But If I configure any thing on that module, I don't see that module in show config.. Any suggestion??

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Cat 6513 Module not showing in show config

There is a reason for that.

show config shows the startup-configuration. If you inserted that module while the switch is running and you've not saved the configuration since then, the modules won't be shown.

show run shows the current running-configuration, any additions and subtraction in the configuration will be shown immediately.

If you want the show config to have the same configuration as show run you must execute wr mem or copy run start

HTH,

__

Edison.

5 REPLIES
Cisco Employee

Re: Cat 6513 Module not showing in show config

Please paste " show version " and " show module " from the chassis.

-amit singh

New Member

Re: Cat 6513 Module not showing in show config

Please find the attached file.

New Member

Re: Cat 6513 Module not showing in show config

I used show run command and I am able to see the module now. I was not able to see the module using show config command. Thanks!!!

Hall of Fame Super Bronze

Re: Cat 6513 Module not showing in show config

There is a reason for that.

show config shows the startup-configuration. If you inserted that module while the switch is running and you've not saved the configuration since then, the modules won't be shown.

show run shows the current running-configuration, any additions and subtraction in the configuration will be shown immediately.

If you want the show config to have the same configuration as show run you must execute wr mem or copy run start

HTH,

__

Edison.

New Member

Re: Cat 6513 Module not showing in show config

Thanks!

I saved the config and now I am able to see the module in slot 13 in show config also.

166
Views
0
Helpful
5
Replies
CreatePlease to create content