Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cat 6k:Inline Power Module - PS volatage bad, cpu @ 85%

My Cat6k running hybrid mode 8.x in the Sup32 is giving the below error and pushing the cpu to 85%.

---------------

SYS-3-SYS_LCPERR3:Module 4: Inline Power Module - PS volatage bad: Module needs troubleshooting or

---------------

Is there any method to stop this module logging the 100's of message per hr? I don't use inline power for anything. The error logging is over driving the CPU.

We plan to replace it, but it will be several days before this is possible.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Cat 6k:Inline Power Module - PS volatage bad, cpu @ 85%

Hello Doug,

if you don't use the module 4 you could

set module power down 4

otherwise you need to disable logging to your telnet session

set logging session disable

and to your console

set logging console disable

or you can try to change the severity level

set logging level sys 6

for more details see

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/configuration/guide/logging.html#wp1020288

Hope to help

Giuseppe

1 REPLY
Hall of Fame Super Silver

Re: Cat 6k:Inline Power Module - PS volatage bad, cpu @ 85%

Hello Doug,

if you don't use the module 4 you could

set module power down 4

otherwise you need to disable logging to your telnet session

set logging session disable

and to your console

set logging console disable

or you can try to change the severity level

set logging level sys 6

for more details see

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/configuration/guide/logging.html#wp1020288

Hope to help

Giuseppe

978
Views
0
Helpful
1
Replies
CreatePlease to create content