We have a cat express 500g and I have assigned it a 10 dot ip address. Now in the intitial setup when you press the setup button you have to have the computer you are going to use to configure the switch, set up to automatically obtain an IP from the switch.
Since I have a IP already configured though, when I go to push the "setup" button, should I configure the computer with an IP on that network or should I get the IP automatically? If I get it automatically, what address do I put in the browser?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...