I've the following questions regarding QoS on IOS XE:
QoS Trust port - Which command should I configure at port configuration level on 10G port which is connected to a switch to trust the packets with DSCP configured received by the other switch? It was not qos trust dscp?
QoS Policing - I've configured a class A referenced to a Policy-map A and I'm trying to setup the following scenario: Max. Bandwidth 40Mbit/s, Policing 20Mbit/s conform-action, exceed-action allocate Bandwidth until 40Mbit/s and violate action drop...Are this the right setup with the right commands???
Policy-map A class-map A bandwidth 40m police 20m 20m conform-action transmit exceed-action transmit violate-action drop
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...