Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat4948 output queuing stats

I'm configuring qos and transmit queuing on a Cat4948 switch, as per below. I cannot find any commands that allow me to view the transmit queue usage. The only commands I can find just show me the config.

interface g1/1

qos trust cos

tx-queue 1

bandwidth 128000 bps

shape 1024000 bps

tx-queue 2

bandwidth 358400 bps

shape 1024000 bps

tx-queue 3

priority high

shape 512000 bps

tx-queue 4

bandwidth 25600 bps

shape 1024000 bps

QoStest-Cat4948#sho qos int g1/1

QoS is enabled globally

Port QoS is enabled

Administrative Port Trust State: 'cos'

Operational Port Trust State: 'cos'

Trust device: none

Default DSCP: 0 Default CoS: 0

Appliance trust: none

Tx-Queue Bandwidth ShapeRate Priority QueueSize

(bps) (bps) (packets)

1 128000 1024000 N/A 2336

2 358400 1024000 N/A 2336

3 250000000 512000 high 2336

4 25600 1024000 N/A 2336

I'm looking for equivalent commands as Cat6500 "sho queueing int g1/1" or Cat3750 "sho platform port-asic stats enqueue f0/1"

Any suggestions appreciated.

Thanks,

2 REPLIES
New Member

Re: Cat4948 output queuing stats

The Cat6500 command only reports frame drops by transmit queue not transmitted frames by transmit queue which is what I want.

I've raised an SR on this and will post any outcome

New Member

Re: Cat4948 output queuing stats

Results of SR:

How to get a report of usage by transmit queue:

C4948 "show interface f0/1 count detail"

C6500 No command available available with current line card revision

131
Views
0
Helpful
2
Replies