Is there any issue with Catalyst 6500 and the new X2 10GBASE-T connectors inside a WS-X6716-10GE module where the connector is not recognized by the sho interface status command? The switch is running IOS 12.2(33)SXH8b.
The connector is unkown as showed in this output:
Te6/9 VNX_DataMover connected 24 full 10G unknown
Te6/10 VNX_DataMover connected 24 full 10G unknown
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...