Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat6500 - Unable to session into any module

Hi,

I am trying to session into any module (for e.g. FWSM) via console and getting the below. This was working before. telnet on the management IP is working though. Please assist.

CAT6500>se sl 1 pr 1

The default escape character is Ctrl-^, then x.

You can also type 'exit' at the remote prompt to end the session

Trying 127.0.0.11 ...

% Connections to that host not permitted from this terminal

1 REPLY
Bronze

Re: Cat6500 - Unable to session into any module

Hello,

Have you checked if console lines are configured on the cards you try to connect apart from vty lines?

127
Views
0
Helpful
1
Replies