We just recently had a power supply gone bad in a 6509 chassis. When checked, the breaker has tripped. Logs showed
"%C6KPWR-SP-2-PSFAIL: power supply 1 output failed". These are WS-CAC-4000W-US in redundant configuration.
We checked the output of the panel and confirmed the voltages are correct. After replacing it with a known good power supply, and confirming the power feed, when we turned on the power, a pop was heared, then the breaker tripped again. The chassis sees the insertion but never the power on. When removed, the switch also sees the removal. Is there a good way to diagnose the power supply outside of the chassis or is the chassis bad already and can cause this problem?
We had a similar issue and it was due to two different problems.
The first issue was that the power suppy had gone bad. The second problem was that the power was not properly distributed to all the power outlets causing an overload that triggered the breaker. Like you, voltage looked good but the problem persisted. Electricians had to dig deeper to find the problem.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.