Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat6509E stuck in Rommon 1>

Hi Netpro,

i am stuck in Rommon , my cat6 can not bootup. need your advice .

thanks.

regard

jack

6 REPLIES
New Member

Re: Cat6509E stuck in Rommon 1>

Get a suitable IOS from Cisco and boot from tftp which could be your laptop

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00800949c3.shtml

New Member

Re: Cat6509E stuck in Rommon 1>

Hi Jack,

Where you doing some thin when it got into rommon.

I assume it is running hybrid IOS ,so is it rommon of SP or RP.

Give configregister value 0x2102 and reset.

Chao

Vishwa

New Member

Re: Cat6509E stuck in Rommon 1>

Hi Vishwa,

this is sup 720 whereby someone itchy hand loaded wrong ios therefore causing switch cant boot up.

your reply will be highly appreciated.

thanks.

regards,

jack

Silver

Re: Cat6509E stuck in Rommon 1>

see if u dont have this file and can help u.

U can use the procedure to copy right image from xmodem.

New Member

Re: Cat6509E stuck in Rommon 1>

Hi Viyuan,

thanks for your doc. it was really helpful but i dont know why ? after new ios loaded and boot path have been setup as well. somehow when i reload , it's went back to Rommon 1> again. :(

your reply will be highly appreciated.

thanks.

jack

Silver

Re: Cat6509E stuck in Rommon 1>

Hi Jack,

Can u please post the message it gives u before Rommon1 prompt

540
Views
9
Helpful
6
Replies
CreatePlease login to create content