Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cat6K MTU Question

Hi all,

I have two C6Ks on the same subnet and they are connected to each other.

One of the switch configure only global mtu (system jumbomtu 1500)

Another of the switch configure mtu 1521 on the interface as follows.

C6K1:
system jumbomtu 1500

interface GigabitEthernet0/1
ip address 10.1.1.1 255.255.255.0

C6K2:
system jumbomtu 9216 (default)

interface GigabitEthernet0/1
mtu 1521
ip address 10.1.1.2 255.255.255.0

When I try to ping 10.1.1.1 size 1521 on the C6K2, I get a fauiler.

But when I change to mtu 1520 on the C6K2, I get a success.
*ping 10.1.1.1 size 1520

In addision, when I change to the system jumbomtu 1501 on the C6K1, it's success.

What is this 20-byte?

Regards,

Tomoyuki

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Cat6K MTU Question

Hello Tomoyuki,

I would suggest to repeat tests using:

set DF bit on packets

you can use the sweep option in extended ping to provide a range of sizes to be explored

Extended commands [n]: y
Source address or interface:
Type of service [0]:
Set DF bit in IP header? [no]: y
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]: y
Sweep min size [36]: 1450
Sweep max size [18024]: 1522
Sweep interval [1]:
Type escape sequence to abort.
Sending 365, [1450..1522]-byte ICMP Echos to 10.X.0.Y, timeout is 2 seconds:
Packet sent with the DF bit set

this should help in understanding what is happening.

I think you see the effect of fragmentation on one side

Hope to help

Giuseppe

Cisco will donate $1 to  the Red Cross Haiti fund for every rated post!

https://supportforums.cisco.com/docs/DOC-8727

2 REPLIES
Hall of Fame Super Silver

Re: Cat6K MTU Question

Hello Tomoyuki,

I would suggest to repeat tests using:

set DF bit on packets

you can use the sweep option in extended ping to provide a range of sizes to be explored

Extended commands [n]: y
Source address or interface:
Type of service [0]:
Set DF bit in IP header? [no]: y
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]: y
Sweep min size [36]: 1450
Sweep max size [18024]: 1522
Sweep interval [1]:
Type escape sequence to abort.
Sending 365, [1450..1522]-byte ICMP Echos to 10.X.0.Y, timeout is 2 seconds:
Packet sent with the DF bit set

this should help in understanding what is happening.

I think you see the effect of fragmentation on one side

Hope to help

Giuseppe

Cisco will donate $1 to  the Red Cross Haiti fund for every rated post!

https://supportforums.cisco.com/docs/DOC-8727

Re: Cat6K MTU Question

Hello Giuseppe,

Thank you for your response.

Regard,

Tomoyuki

520
Views
0
Helpful
2
Replies