I have both cat6 switches connect together via 5x Gigabit ethernet (Etherchannel). The port-channel interface assign with vlan55. Interface Vlan55 is use as point2point routed interface between 2 cat6 switches.
I have an questions :
1) Cat6 , SVI interface does it have limitation the speed it can handle ?
Can it handle line speed of 5x GE (5Gbbps) in port-channel ?
2) Can we configure the BW command on interface to 5Gbps if we knew it going to have physical speed of 5Gbps on VLAN55. Reason is the MTRG show over 1Gbps on SVI right now..and I belived the SVI now is running more that 1 Gbps.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...