Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

catalatsy 2960G-48 duplex mismatch on fiber

hello.

have to 2960G-48TC-L sw with a GLC-FE-100FX fiber mod installed, the distanse is about 1km. and I can't get the port on the sw to be full duplex. i have upgrade the sw frimware to 12.2.40SE inn hope that is was a firmware error. it wasen't. anyone ho know haw to del with this?

1 REPLY
New Member

Re: catalatsy 2960G-48 duplex mismatch on fiber

Hi

Make soure the interface with the gbic, is configured with the right media type.

int xx

media type gbic

After that it is possible to set the speed off the interface to 100Mbit and full duplex.

334
Views
5
Helpful
1
Replies
CreatePlease login to create content