cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
358
Views
0
Helpful
0
Replies

Catalust 3850 uplink in UDLD error-disable

S891
Level 2
Level 2

We have connected new Catlyst 3850s 10g uplink with Cata 6800. 

These uplinks are in form of a port-channel. All the config is already setup with switch priority. 

I am seeing a large of error-dable states on  catalyst 6807 for the 3850s. These are all UDLD errors. Even after swap of  optics  and cables the error is still there. Not sure if this is known error. 

The only solution was to disable UDLD from the 6800 inerace, after that things were noral. What is the potental draw bak of disabling UDLD on interface and also what is the recommended config. 

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: