Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 2900 Series XL

I have a 2924M-XL switch that i erased the flash memeory on. How can I get it back on there so I can configure the switch?

2 REPLIES

Re: Catalyst 2900 Series XL

when you say erased flash you probably erased everything including the image code.

you need to get the code and upload it back into the switch in order to bring it up for configuration.

do you see an rommon> promtp?

Re: Catalyst 2900 Series XL

If your switch is not in the Rommon, then you can load an IOS image back to the switch with the following command

copy tftp: flash:

and change the boot path with the help of

boot system flash:

If the switch is in Rommon mode then you have to do a disaster recovery.

http://www.cisco.com/en/US/products/hw/switches/ps607/products_tech_note09186a0080094955.shtml

HTH

Narayan

146
Views
0
Helpful
2
Replies
CreatePlease login to create content