Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 2948G-GE-TX

hi all,

can anyone pls tell me the command to make anyother vlan as "native vlan" other than the default vlan 1 in catalyst 2948G-GE-TX switch.

cheerio,

Sathish

2 REPLIES
Cisco Employee

Re: Catalyst 2948G-GE-TX

They way to do this is first configure the port to be a part of the VLAN that you need to configure as native vlan. For example if you want vlan 3 to be your native vlan and your trunk port is 1/2, then do the following

Set vlan 3 1/2, this will set tthe port 1/2 to vlan 3.

Then configure the port as trunk port and the vlan 3 will become native vlan on trunk 1/2

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/7_5/config/e_trunk.htm

HTH,Please rate if it does.

-amit singh

set trunk 1/2 on dot1q

HTH,Please rate if it does.

-amit singh

New Member

Re: Catalyst 2948G-GE-TX

thx a lot amit.....

cheerio.

403
Views
0
Helpful
2
Replies