Ok,here I go.
I've downloaded and installed the new " IOS (tm) C2950 Software (C2950-I6K2L2Q4-M), Version 12.1(22)EA14, RELEASE SOFTWARE (fc1)" to get the "ssh" option. Used TFTP.
I did the boot system flash pointing to the new IOS version.
switch: boot
Loading "flash:c2950-i6k2l2q4-mz.121-22.EA14.bin"...#######
It rebooted normally with the new IOS version, nevertheless I got the "switch:" prompt nevertheless I don't have the command "enable". I got stuck with "switch:"
Now all the commands I have available are as below:
switch: ?
? -- Present list of available commands
boot -- Load and boot an executable image
cat -- Concatenate (type) file(s)
copy -- Copy a file
delete -- Delete file(s)
dir -- List files in directories
flash_init -- Initialize flash filesystem(s)
format -- Format a filesystem
fsck -- Check filesystem consistency
help -- Present list of available commands
load_helper -- Load and initialize a helper image
memory -- Present memory heap utilization information
mkdir -- Create dir(s)
more -- Concatenate (display) file(s)
rename -- Rename a file
reset -- Reset the system
rmdir -- Delete empty dir(s)
set -- Set or display environment variables
set_param -- Set system parameters in flash
trap -- Cause a software breakpoint to occur
type -- Concatenate (type) file(s)
-- MORE --
unset -- Unset one or more environment variables
version -- Display boot loader version
switch:
Please, any idea?
