I have a catalyst 2950-24 switch in use for part of my floor machines. The switch is connected back into the server and has another switch connected to in the the Gig 2 port. Currently I have 24 IP phones and computers connected to the switch. However, I can only have 22 connected at one time. If I free up 1 port, another one will work. All ports are configured alike. I thought at first it was a cable issue, but the two cables that I thought were the issue will work if I free up 2 other ports. These 2 cables go directly into the switch while the others go through a patch panel. Any suggestions? I need all 24 ports to talk to my setups.
Sounds like maybe you have a couple of ports that are somehow connected in a loop and spanning tree is shutting them off , that is the only reason I can think for something like that to happen . Use the command show spanning tree blockedports to see if this is happening.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...