Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 2955 Relay Connector Information Needed

Hi all :

I come across to use the Catalyst Switch 2955 and it has two Relay Connector with one Major (MAJ) and one Minor (MIN) as below picture.relay connector.gifrelay connector1.gif

relay connector.gif

There is command line to trigger these two Relay Connectors. As below command to set the Relay Connector to minor for monitoring the power supply :

alarm facility power-supply relay minor

1. My questions are when there is power-supply faulty, the Minor Relay Connctor (right picture) will be short-circuited, right?

2. If we connector the two ports (ports 4 & 5 at the left picture) with a normal cable to drive an Alram Bell (in short-circuiled or closed loop situation), do we need an external power supply to the Alram Bell? Or there will be power supply from Catalyst 2955 to the Alram Bell as well?

Thanks!

Best regards,

tangsuan

1 REPLY
New Member

Catalyst 2955 Relay Connector Information Needed

Hi all :

Is there any body know the answer of this question?

Thanks!

282
Views
0
Helpful
1
Replies