cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
501
Views
0
Helpful
4
Replies

Catalyst 2960 after upgrade

csco11579831
Level 1
Level 1

hello,

I have a Catalyst 2960 series switch after upd blocked by the Web console,

I turned on the switch and connected the console cable but it does not reponds, LED Lighted system remains,

I feel that the update process was interrupted because that I was trying to update the others switchs at the same time,and all switch are cascaded,

can you please help me?

Regards,

1 Accepted Solution

Accepted Solutions

RMA stands for Return to Manufacturer's Agreement. 

This means that you can contact Cisco TAC and ask them to replace your broken hardware. 

This, of course, is possible if you have a valid maintenance contract with Cisco.

View solution in original post

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame

If you've tried two or three different clients and you can't get anything (not even garbage characters) from console then there's a sure chance the appliance is toast.

Your remedial action would be to raise a TAC Case and get the appliance RMA-ed.

Hi Leo!

Yes, actually I tested for several clients and with others console cable,
and when I tried to connect with another switch that works,
What is the appliance RMA-ed?

RMA stands for Return to Manufacturer's Agreement. 

This means that you can contact Cisco TAC and ask them to replace your broken hardware. 

This, of course, is possible if you have a valid maintenance contract with Cisco.

OK,Thanks !

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco