CPU utilization for five seconds: 33%/1%; one minute: 34%; five minutes: 35% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 137 1130229138 72291065 15634 25.99% 25.54% 25.42% 0 Hulc LED Process
ARWWA-SW-C2960S#show processes cpu sorted 5min CPU utilization for five seconds: 34%/1%; one minute: 34%; five minutes: 35% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 137 1130236489 72291533 15634 25.86% 25.52% 25.42% 0 Hulc LED Process
Could you please advise what this "Hulc LED Process" is? Has anyone encountered this issue before?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...