Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 2960 not usable

I've just moved my switches onto another UPS and a couple of my 2960s are no longer working properly. In HyperTerminal, a message comes up saying "!!! WARNING: The switch is not usable !!!" Also the System and RPS LEDs are amber. If someone knows how to fix this problem, any help would be greatly appreciated

1 REPLY

Re: Catalyst 2960 not usable

Ryan,

It sounds like your switch took a power surge, and it is not going to work. You should contact TAC and get this switch replaced under RMA.

Amber System LED: : System is receiving power but is not functioning properly.

Amber RPS LED: The RPS is in standby mode or in a fault condition. Press the Standby/Active button on the RPS, and the LED should turn green. If it does not, the RPS fan could have failed. Contact Cisco Systems.

Mark

182
Views
0
Helpful
1
Replies