06-29-2010 05:09 PM - edited 03-06-2019 11:49 AM
I'm trying to set up my 2960-S (POE) switch with the express setup. I have used the express setup on multiple 2960-G (none-POE) switches and it has workd fine. However, when I use it on the POE, and I try to enter 10.0.0.1 in my browser it askes me for a username and password, which I dont have because this is the first time this switch has been set up.
On the none-POE switch it was inside the 10.0.0.1 window that I set up the username and password. Is there some default username/password for the POE version of the switch?
I have tried resetting the switch to factory configuration, and it still asks for the username/password after I enter express setup.
All I'm trying to do is set up the IP address, name, and password.
Any help would be appreciated.
Thank you,
Erik
Solved! Go to Solution.
06-29-2010 05:20 PM
06-29-2010 05:20 PM
Username: Cisco
Password: Cisco
07-01-2010 09:03 AM
Thank you, that did the trick!
Erik
07-01-2010 03:24 PM
Thanks for the ratings, Erik. I'm glad to be of some assistance.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide