Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 2960 s Express Setup

I'm trying to set up my 2960-S (POE) switch with the express setup. I have used the express setup on multiple 2960-G (none-POE) switches and it has workd fine. However, when I use it on the POE, and I try to enter 10.0.0.1 in my browser it askes me for a username and password, which I dont have because this is the first time this switch has been set up.

On the none-POE switch it was inside the 10.0.0.1 window that I set up the username and password. Is there some default username/password for the POE version of the switch?

I have tried resetting the switch to factory configuration, and it still asks for the username/password after I enter express setup.

All I'm trying to do is set up the IP address, name, and password.

Any help would be appreciated.

Thank you,

Erik

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Catalyst 2960 s Express Setup

Username:  Cisco

Password:  Cisco

3 REPLIES
Hall of Fame Super Gold

Re: Catalyst 2960 s Express Setup

Username:  Cisco

Password:  Cisco

New Member

Re: Catalyst 2960 s Express Setup

Thank you, that did the trick!

Erik

Hall of Fame Super Gold

Re: Catalyst 2960 s Express Setup

Thanks for the ratings, Erik.  I'm glad to be of some assistance.

4121
Views
0
Helpful
3
Replies