Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 2960-x series. Static IP device was not able to get connection.

We recently purchase a cisco switch catalyst 2960-x series. 1 of the port seems to be refreshing 1 network point frequently, then another port connected to a static IP printer is down too, I couldn't ping the IP address. But when I change to Another switch, it is working fine.

 

I did a direct connect from that port to my laptop was ok but strangely why is it not working for a static IP printer?

 

Is there any configuration regarding connecting static IP?

  • LAN Switching and Routing
3 REPLIES

Hi Derrick,It is tough to

Hi Derrick,

It is tough to answer based on above information. But can you please ensure the switch port is in the right vlan for that subnet from where you used the static ip?  Alternately you can check which vlan that port belongs to and configure an ip address from that vlan to the printer. 

 

Also share all relevant details. From where you are pinging ? Are you on the same vlan or different vlan? Share port config etc so that we can help you further.

Hope this helps and kindly grade my post if it is helpful to you.

 

Thanks,

Madhu

 

New Member

Hi krishnan, I just try show

Hi krishnan,

 


 

I just try show run and the result seems to hang at interface GigabitEthernet1/0/12..

 

586521b3#
586521b3#show run
Building configuration...

Current configuration : 1549 bytes
!
! Last configuration change at 02:31:25 UTC Wed Apr 29 2015
!
version 15.0
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname 586521b3
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model
switch 1 provision ws-c2960x-24ts-l
!
!
!
!
!
spanning-tree mode pvst
spanning-tree extend system-id
!
!
!
!
!
!
vlan internal allocation policy ascending
!
!
!
!
!
!
interface FastEthernet0
 ip address dhcp
!
interface GigabitEthernet1/0/1
!
interface GigabitEthernet1/0/2
!
interface GigabitEthernet1/0/3
!
interface GigabitEthernet1/0/4
!
interface GigabitEthernet1/0/5
!
interface GigabitEthernet1/0/6
!
interface GigabitEthernet1/0/7
!
interface GigabitEthernet1/0/8
!
interface GigabitEthernet1/0/9
!
interface GigabitEthernet1/0/10
!
interface GigabitEthernet1/0/11
!
interface GigabitEthernet1/0/12
!

We have not configure any Vlan  for subnet.

 

Regards

Derrick

 

 

 

New Member

Hi Derrick.You said output

Hi Derrick.

You said output hangs at Gi1/0/12?

What happens if you press the [Space] bar on your keyboard? Please try that if you haven't already done so and post the results.

I'll do my best to help you.

Regards,

John

 

193
Views
0
Helpful
3
Replies