ā11-27-2011 06:28 AM - edited ā03-07-2019 03:37 AM
Hello,
we have Catalysts 2960S for switching in our Wireless high capacity backbone network. As agregation switch we are using 3560x.
I just need to know, if are these 2960S good solution for igmp snooping for whole IPTV stream. It put only a range from backbone and put out on another port. But just specified multicast addresses.
Imput will be 239.128.0.10 to 239.128.0.20 on Gi 0/1
Output wil be 239.128.0.10 - 15 on Gi 0/24
IPTV will be separated on different VLAN for eg VLAN 20
Is needed any priorization configured od switches?
The capacity for IPTV is around 500 mbps
Thank you very much!
BR
dave
ā11-27-2011 12:49 PM
The capacity for IPTV is around 500 mbps
I presume your uplink is 10Gb?
ā11-27-2011 01:03 PM
No, my uplink or radio network is 1 gig only. 2960S doesnt support 10 gig as i know.
ā11-27-2011 01:07 PM
2960S comes in two flavours: The plain has 1 Gb uplink and the "D" series has 1 Gb or 10 Gb uplink.
You may want to etherchannel your uplinks. A single 1Gb uplink, in my humble opinion, will not be enough.
ā11-27-2011 01:16 PM
Thank you !
in bacbone uplink are 2 Vlans.
VLAN 20 - IPTV = 500 Mbit
VLAN 80 - NET = 200 Mbit
I hope it is enough
Uplink port is Gi 0/1
Downlink port for IPTV is gi 0/24 with 300 Mbit IPTV traffic
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide